X-Factor X–60 - Page 6

X – 60 Instructions Version 1.0 Page 6
5) Remove the two flat head screws which hold the
bulkhead to the chassis. Save them for re-use.
6) From the top of the truck, remove the center screw
holding the top plate to the post on the T4 chassis.
Save the screw for re-use.
7) Remove the two side top plate screws. Save them for re-use. Carefully remove
the front end and steering assembly, and set it aside for re-use. Make sure the
steering linkage stays in place.
That’s it! Let’s do the rear of the truck.