18
19
Power supply from the USB connection to an external medium is not guaranteed, e.g.
to a hard disk. Please refer to the connected storage medium’s instruction manual for
further information.
Optical output
› Use an optical cable to connect the „Signal Output” jacks on the device to the respective optical
input jacks.
Chapter 5 Basic operationChapter 4 Connection
Setup
› You will be asked if „Setup Wizard” is to be started, when the device is turned on for the rst
time. If you don’t want this to be installed or it is to be started at a later point in time, you will be
able to start this setup function again as follows:
MENU › System settings › Setup Wizard
The following will occur, if the „Setup Wizard” is carried out:
› You can select the desired time format (12/24 hour display).
› Whether and which source is to carry out automatic updates.
› Your time zone (Germany has the time zone +01:00)
› Set the daylight savings options ON/OFF
› Select the WLAN coverage area (for Germany please select „Most of Europe“)
5
Basic operation
To Next Page
Loading...
