X4-TECH IR-1200 - Network Profi Le; Stations

22
23
Chapter 7 Internet radioChapter 7 Internet radio
4. Gateway address
Set the Gateway address with „“ and „“ or with the „CONTROL“ dial. Use the „“ and „“
buttons to switch between  elds. Press „ENTER“ to switch to the next  eld.
5. DNS
If the DHCP has been deactivated, then the primary and secondary DNS address can be set
with „“ and „“ or with the „CONTROL“ dial. Use the „“ and „“ buttons to switch between
 elds. Press „ENTER“ to switch to the next  eld.
Beyond a wireless network:
6. SSID
Set the wireless network identi cation. Use the navigation buttons or the „CONTROL” dial to
move the cursor through the displayed characters. Press either the „ENTER” button or the „CON-
TROL” dial to con rm the selected character.
› Select „BKSP“ to delete the last character selected.
› Select „CANCEL“ to cancel your input.
› Select „OK“ to con rm the entered code and to try to establish a connection to the selected
network.
7. Authentication
Now set the preferred method of authentication.
Open, Pre-Shared Key (PSK), WPA (Wi-Fi Protected Access) or WPA2.
8. Encryption type
Now select the appropriate encryption type.
Disabled (o ) or WEP (Wired Equivalent Privacy) for Open or PSK, TKIP (Temporal Key Integrity
Protocol) or AES (Advanced Encryption Standard).
9. Key
Now enter the code for the wireless network. Use the navigation buttons or the „CONTROL” dial
to move the cursor through the displayed characters. Press either the „ENTER” button or the
„CONTROL” dial to con rm the selected character.
› Select „BKSP“ to delete the last character selected.
› Select „CANCEL“ to cancel your input.
› Select „OK“ to con rm the entered code and to try to establish a connection to the selected
network.
Now the device will try to establish a connection using the data previously entered.
Network pro le
› You can use the options MENU › System settings › Network › Network Pro le to delete an un-
wanted network. Here you will see a list of the previously used wireless networks. Select a pro le
with the „“ and „“ buttons and press „ENTER“. Con rm with „YES” to delete.
Stations
Selecting a station
› You can use the „“, „“ and „“ buttons or turn the „CONTROL“ dial to open a menu station
list. Use the „“ and „“ button or turn the „CONTROL“ dial to navigate through the menu and
to select a station. Press „“, „ENTER“ or „CONTROL“ dial to switch to the selected station.
› You can also search for a certain station by selecting MENU › Station List › Stations › Search sta-
tions.
› Use the navigation buttons or the „CONTROL“ dial to move the cursor through the displayed
characters. Press either the „ENTER“ button or the „CONTROL“ dial to con rm the selected cha-
racter.
› Select „BKSP“ to delete the last character selected.
› Select „CANCEL“ to cancel your input.
› Select „OK“ to start searching.
The device will search for all stations with the same entered key characters. Once a search has
been completed, a list of all stations found will be displayed.
› There are various ways to select a stored station.
› Press a numeric button to select a memory preset. Press the „SHIFT” button  rst and then the
1 – 5 button to select a preset station between 6 and 10.
Example
To select station preset 8, press the „SHIFT” button  rst and then the number „3”.
› Press „P” down shortly to display a list of stored stations. Use the „“ and „“ buttons or turn
the „CONTROL“ dial to select the preferred station. Press the „ENTER” button or the „CONTROL”
dial to con rm and switch to the selected station. Press „“, „P“ or „BACK“ to exit this menu. The