5
www.xa.com/en
Using the XAG™ GC4000+ Auto Super Charge Station
XAG™ GC4000+ Auto Super Charge Station is designed specifically for the charging of XAG Smart
Battery, and it shall not be used for other purposes.
For compatible Batteries (Models coded B*****S ending with “S”), the batteries require
approximately 12 minutes for a full charge under normal operating conditions.
For other XAG Battery not compatible for Super Charge, the charging time is depended on the
maximum current allowed by the battery.
Note
The default charging adapter of XAG™ GC4000+ Auto Super Charge Station is only applicable
for the XAG B13960S Smart Battery. If you need to use this product for other B-Series batteries,
please contact your nearest distributor for the appropriate adapters.
🔎
CHECK :
Before using the device, please make sure that the fuel switch is turned on and the red emergen-
cy stop switch on the left side of the control panel is in the pop-up state. After confirmation, con-
nect the charging adapter to the smart battery that requires charging.
To Next Page
Loading...