Xantrex Trace 1012 UR-UPS - Figure 2-5 Jumper Location; Table 2-1 Jumper Settings

10
2.0 Installation
©2002 Xantrex Technology Inc. All Rights Reserved.
P/N 975-0049-01-01 Rev A 10/2002
To Configure the Trace UR-UPS (continued)
The jumpers in the Trace UR-UPS are located on the
main circuit board and are labeled JP1 for AC transfer
sensitivy, JP2 for battery type selection, JP3 for depth-of-
discharge, and JP4 for Option B (which is not used at this
time).
1. To access the jumpers, remove the top cover from the
unit following the instructions on page 8.
2. Locate the configuration jumpers on the main
printed circuit board.
3. Either install or remove (store) the jumpers
depending upon the desired configuration. Use
needle-nose pliers to carefully remove the jumpers.
Table 2-1
Jumper Settings
Figure 2-5
Jumper Location
CAUTION: Be
extremely careful
when removing
and/or installing
the jumpers. Do
NOT bend the pins
as permanent
damage to the
circuit board can
occur.
Jumper Location
repmuJ
DI
noitcnuF )tluafeD(NOrepmuJ FFOrepmuJ
1PJ
refsnarTCA
ytivitisneS
)tuonworB(
edoMSPU
caV031-501
smr
edoMNEG
caV041-09
smr
2PJ
epyTyrettaB
noitceleS
)MGA(/)leG(delaeS
cdV3.41=kluB
setunim06=emiTnoitprosbA
cdV4.31=stloVtaolF
)dicAdaeLdedoolF(diuqiL
cdV7.41=kluB
setunim06=emiTnoitprosbA
cdV2.31=stloVtaolF
3PJ
egrahcsiDfohtpeD
egatloVwoL(
))DVL(egrahcsiD
egrahcsiDpeeD
>
cdV6.01
egrahcsiDwollahS
<
cdV7.11
4PJ BnoitpO DESUTON DESUTON
Main Circuit Board