Xantrex Trace 1012 UR-UPS - Figure 2-9 Setting Option B (JP4) (Not Applicable at this Time); Setting Option B (JP4

To Next Page

To Previous Page

2.0 Installation

P/N 975-0049-01-01 Rev A 10/2002

To Configure the Trace UR-UPS (continued)

Setting Option B (JP4 - OPTION B) (Not used)

This jumper assignment is currently not used. Disregard

this jumper setting until further notice or unless told to

remove it by an authorized Xantrex Customer Service

Representative.

• JUMPER ON: Default position (N/A)

• JUMPER OFF: N/A

Figure 2-9

Setting Option B (JP4) (Not Used at this time)

Jumper OFF: Do not remove the jumper

unless instructed to do so by an authorized

Xantrex Customer Service Representative.

Jumper ON: This is the default configura-

tion.

WARNING:

CHANGING

CONFIGURATION

SETTINGS

REQUIRES ALL

SOURCES OF

POWER (AC AND

DC) BE

DISCONNECTED

FROM THE TRACE

UR-UPS.

Xantrex Trace 1012 UR-UPS - Figure 2-9 Setting Option B (JP4) (Not Applicable at this Time); Setting Option B (JP4 - OPTION B) (Not Used)