Need help?Do you have a question about the Xantrex XKW 40-25 and is the answer not in the manual?
General| Brand | Xantrex |
|---|---|
| Model | XKW 40-25 |
| Category | Power Supply |
| Language | English |
Details warranty coverage duration and scope for the DC Power Supply.
Explains Xantrex's obligations for repair or replacement under warranty.
Provides contact information for obtaining warranty service and support.
Lists conditions and damages not covered by the limited warranty.
Defines safety symbols and provides critical safety instructions for power supply operation.
Outlines the structure and content of the operating manual, describing key sections.
Introduces the XKW Series power supplies, highlighting their capabilities and technology.
Lists key features and optional capabilities of the XKW Series power supplies.
Describes the controls, indicators, and displays located on the front panel.
Details the connectors and internal switch located on the rear panel of the power supply.
Provides an overview of various controls, connectors, and indicators on the unit.
Presents detailed electrical specifications for the XKW Series power supply models.
Lists further specifications including rise time, fall time, and transient response.
Outlines the required input voltage, current, frequency, and power factor.
Describes features like switching frequency, hold-up time, and insulation resistance.
Explains remote start/stop, interlock, monitoring, and compensation capabilities.
Details operating and storage temperature, humidity, and altitude requirements.
Covers physical dimensions, weight, connector types, and approvals.
Provides guidance on inspecting, installing, and testing the power supply.
Summarizes the essential steps for setting up the power supply.
Details initial inspection procedures and methods for periodic cleaning.
Outlines the policy and procedure for returning units for service or repair.
Provides instructions for safely packaging the unit for shipping or storage.
Guides on proper placement, mounting in racks, and ensuring adequate ventilation.
Covers connecting AC power and selecting the correct input voltage.
Describes procedures for performing functional tests on the power supply.
Explains how to check and verify voltage mode operation.
Details the steps to check and verify current mode operation.
Provides guidance on connecting the load and ensuring stable, low-noise output.
Shows current carrying capacity for various wire gauges used in load wiring.
Explains how to assemble and attach the strain relief for the DC output connector.
Describes the use and connection of local and remote sensing for regulation.
Guides on operating a single power supply using front panel controls.
Discusses operating multiple units in series, parallel, or split configurations.
Explains how to connect units in series for higher voltage output.
Details how to connect units in parallel for higher current output.
Describes obtaining dual positive or positive-negative outputs.
Explains the OVP circuit function, activation, and reset procedures.
Provides steps to set the OVP trip level using the front panel potentiometer.
Details how to remotely program OVP using a 0-5V or 0-10V voltage source.
Explains how to remotely program OVP using a 5k ohm external potentiometer.
Details programming OVP using a 0-1mA current source.
Describes shifting the OVP sensing point from the output terminals to the sense lines.
Explains how to remotely control the power supply output using TTL or AC/DC inputs.
Details using an external relay for remote ON/OFF control via contact closure.
Introduces remote programming of output voltage and current limit via J3 connector.
Explains the functions of switch SW1 for controlling programming scales and modes.
Details programming output voltage using external 0-5Vdc and 0-10Vdc sources.
Explains how to program output current limit using a 5k ohm potentiometer.
Details programming output voltage and current limit using a 0-1mA current source.
Describes readback signals for voltage/current and status indicators available via J3.
Explains the OTP circuit and how to reset it after a shutdown.
Introduces the calibration process and safety precautions.
Guides on setting up the environment and tools for calibration.
Lists essential safety practices and environmental considerations for calibration.
Details the trimpot designations and parameters affected during calibration.
To Next Page