• AAuuttoo PPoowweerr OOffff: To allow the device to power off after a period of time in Sleep Mode, select Auto Power Off.
To set the delay before the printer powers off from the Sleep Mode setting, enter the number of hours.
To change the Energy Saver mode settings, refer to the System Administrator Guide at www.xerox.com/office/
ALC81XXdocs. For further assistance, contact your System Administrator.
To learn more about Xerox participation in sustainability initiatives, go to: www.xerox.com/environment or www.
xerox.com/environment_europe.
Note:
• Energy Saver cannot be deactivated.
• Changing the default Energy Saver activation times can result in an overall higher energy consumption
of the device. Before you set a long activation time for Energy Saver modes, consider the increase in
device power consumption.
Default Energy Saver Settings
This device is ENERGY STAR
®
-qualified under the ENERGY STAR Program Requirements for Imaging Equipment. The
transition time from Ready mode to Sleep mode can be set from 0–60 or 0–120 minutes, depending on printer
model. The default value is set to 0 minutes. The maximum transition time from Ready mode to Sleep mode can
take up to 120 minutes, depending on printer model.
To change the Energy Saver settings, contact your System Administrator, or refer to the System Administrator Guide
at: www.xerox.com/office/ALC81XXdocs
EURASIAN ECONOMIC COMMUNITY CERTIFICATION
Russia, Belarus, and Kazakhstan are working to establish a common customs union, the Eurasian
Economic Community, or EurAsEC. The Eurasian Economic Community members anticipate
sharing a common regulatory scheme and common EurAsEC certification mark, the EAC Mark.
Regulatory Information for 2.4-GHz and 5-GHz Wireless Network Adapters
This product contains a 2.4-GHz and 5-GHz Wireless LAN radio transmitter module that complies with the
requirements specified in FCC Part 15, Industry Canada RSS-210, and European Council Directive 2014/53/EU.
Radio Frequency (RF) output power of this device does not exceed 20 dBm in either frequency band.
Operation of this device is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that can cause an undesired operation.
Changes or modifications to this device not approved by the Xerox Corporation can void the user’s authority to
operate this equipment.
Xerox
®
AltaLink
®
C8130/C8135/C8145/C8155/C8170 Multifunction Printers Safety, Regulatory, Recycling, and Disposal
Reference Guide
19
Regulatory Information
To Next Page
Loading...
Need help?
General
