Back to Previous Page
57
Use WPS to add the printer to the Wi-Fi network.
Perform the following steps:
1. Activate WPS from your router, if required. Some routers have a
WPS button on them and others require configuration from the
router’s interface/web page. Refer to your router’s user
documentation.
2. Push and hold WPS button on the printer for 2 seconds.
3. Wait 2-3 minutes for the blue WPS button to stop flashing.
4. Wait approximately 1 minute for the printer to obtain a valid IP
address.
5. Press the red Stop button to print a configuration report and verify
that an IP address was obtained.
➢ For more detailed steps to verify the IP address, click here.
Add the Printer to the Wireless Network via WPS
Next
Back to Start
Try a different method to setup WiFi
To Next Page
Loading...
