Why is my Xerox Printer copy shifting slightly?
If your Xerox Printer copies are shifting slightly, the paper may be shifting or the leading edge of the paper is not loaded flush with the tray corners. Load the paper so that it is flush against the paper tray corners.
Why does my Xerox Printer keep jamming and wrinkling paper?
Frequent paper jams and wrinkled paper in your Xerox Printer can be due to several factors: * The paper might not be loaded correctly in the paper tray; ensure it's loaded properly. * The paper tray might not be fully inserted; push it in firmly as far as it can go. * The paper could be damp; replace it with paper from a new ream. * The paper could be curled; try turning the paper over so the curl faces down, or use a new ream.
What to do if my Xerox PrimeLink B9125 Printer is unable to print or copy?
If your Xerox Printer is unable to print or copy, here are a few things to check: First, see if there's a message on the control panel and follow the instructions provided. Second, make sure the printer isn't in offline mode by pressing the Machine Status button and selecting Online. Finally, ensure the power cord is properly connected to both the printer and the power outlet; if disconnected, turn the power off, plug it in securely, and then turn the power back on.
Why am I unable to send email from my Xerox PrimeLink B9125 Printer?
If you are unable to send email from your Xerox Printer, verify that the email address is correct. Also, the maximum sending email size might be exceeded; change the maximum sending email size, or reduce the resolution.
Why are images skewed on my Xerox PrimeLink B9125 Printer copies?
If images on your Xerox Printer copies are skewed, it could be due to several reasons. Ensure the document is loaded correctly. Check that the paper is loaded properly in the tray. For Tray 5 (Bypass), make sure the paper guide is set so that the tray touches the paper. Also, ensure the document guides are correctly positioned and aligned with the document's edge. Finally, verify that the paper tray is properly set by pushing it in as far as possible.
How to fix a folded corner on a Xerox PrimeLink B9125 document?
If a corner of the document is folded when using your Xerox Printer, it's likely because the document is curled. Flatten out the curl and then load the document again.
Why is the printing faint on the entire page from my Xerox PrimeLink B9125?
If the printing is faint on the entire page from your Xerox Printer, the print was made using Tray 5 (Bypass), and the size and type of the loaded paper differed from the setting on the print driver. Load paper of the correct size and type into Bypass, Tray 5. Fan the paper thoroughly before you load it. Alternatively, two or more sheets may be feeding at the same time; fan the paper thoroughly, then reset the paper.
Why does paper become wrinkled when using my Xerox PrimeLink B9125 Printer?
If paper becomes wrinkled when using your Xerox Printer, the paper in use may be unsuitable; replace with paper from a new ream.
Why are text or images printed at an angle from my Xerox PrimeLink B9125 Printer?
If text or images are printed at an angle from your Xerox Printer, the paper guide in the paper tray is not set at the correct position. Set the horizontal and vertical paper guides to the correct positions.
Why does the printed toner smudge when rubbed on my Xerox prints?
If the printed toner smudges when rubbed on your Xerox prints, it could be due to a couple of reasons. The paper might be damp, so try replacing it with paper from a new ream. Alternatively, the paper you're using might be unsuitable; try loading suitable paper.
General instructions for safe printer operation and compliance with safety agency evaluations.
Guidelines for safe electrical connections, power cords, and emergency power off procedures.
Safe practices during printer operation, handling hot areas, and environmental considerations.
Information about Class 1 laser safety standards for North America and the European Union.
Procedures for printing documents over a network using PostScript and PCL drivers.
Step-by-step guide for making copies using the automatic document feeder.
Instructions for making copies using the document glass.
Explains various scan methods like Email, Network Scanning, Scan to PC, and Store to USB.
Step-by-step guide for sending faxes using the multifunction printer's embedded fax.
Instructions for sending faxes via email by scanning the document.
Step-by-step guide on how to register and store a program with custom settings.
General guidelines for loading, printing, and storing various types of media, including labels and glossy paper.
Procedures for cleaning the printer's exterior, touch screen, document glass, and feeder rollers.
Instructions for checking and replacing consumable supplies like toner cartridges and waste containers.
Addresses common printer issues such as no power, dark display, and unable to print.
Solutions for common image quality problems like dirty copies, skewed images, and incorrect sizing.
Instructions for clearing paper jams in various locations within the printer and feeders.
Instructions for loading paper and special media into the Standard and XLS Bypass trays.
Step-by-step guide on how to load paper into the HCF trays and adjust paper guides.
Instructions for loading paper and special media into the OHCF trays.
To Next Page
General