Xerox C235 - Page 131

שומיש תספדמה יטירפתב
Xerox
®
C235 תינועבצ תבלושמ תספדמ
שמתשמל ךירדמ
131
Menu Item
Description
– Enable*
– Disable
Device Operations
Clear Custom Status
Erase user-defined strings for the Default or Alternate custom
messages.
Device Operations
Clear all remotely-installed messages
Erase messages that were remotely installed.
Note: This menu item is available only in some printer
models.
Toner patch sensor setup
• Calibration frequency preference
– Disabled
– Fewest color adjustments
– Fewer color adjustments
– Normal*
– Better color accuracy
– Best color accuracy
Set the default calibration frequency.
Toner patch sensor setup
Full calibration
Run the full color calibration.
Toner patch sensor setup
Print TPS information page
Print a diagnostic page that contains toner patch sensor calibration.
Scanner Configuration
• Scanner Manual Registration
– Print Quick Test
Print a Quick Test target page.
Note: Make sure that the margin spacing on the target page is
uniform all the way around the target. If it is not, then the
printer margins may need to be reset.
Scanner Configuration
• Scanner Manual Registration
– Front ADF Registration
– Rear ADF Registration
– Flatbed Registration
Manually register the flatbed and ADF after replacing the ADF,
scanner glass, or controller board.
Scanner Configuration
• Edge Erase
– Flatbed Edge Erase
0–6 (3*)
– ADF Edge Erase
0–6 (3*)
Set the size, in millimeters, of the no-print area around an ADF or
flatbed scan job.
Scanner Configuration
• Disable Scanner
Disable the scanner when it is not working properly.