How to fix Xerox Phaser 5335 Printer that will not switch on?
First, ensure the power switch is in the position. If that doesn't work, try switching the power off, firmly plugging the power cord into both the power connector and the outlet, and then switching the power back on. Also, make sure the printer is connected to a power outlet that provides the correct voltage and current, and avoid sharing the outlet with other devices.
What to do if my Xerox Phaser 5335 Printer output is too light (faded or unclear)?
If the output from your Xerox printer is too light, try these solutions: Ensure you are using fresh paper that is appropriate for the printer. If the toner save feature is enabled, disable it by clearing the [Draft Mode] check box on the [Detailed Settings] tab in your print driver. Also, adjust the print density settings under the [Graphics] tab > [Image Settings] in your print driver. Finally, check and change the [Paper Type] setting and try printing again.
What to do if my Xerox Phaser 5335 Printer will not print?
If your Xerox printer is not printing, and your computer is connected via a parallel cable, check if your computer supports bi-directional communication. If not, disable bi-directional communication on the printer's control panel. If your printer is connected to a network, verify that the printer's IP address is set correctly.
Why does my Xerox Printer not correctly select a paper tray?
If your Xerox printer isn't selecting the correct paper tray, and you switched on the power when the trays were removed, push the trays firmly into the printer, and switch the printer off and then on again. Also, ensure the paper size specified with the paper size dial matches the size of paper loaded in the tray.
How to resolve equally spaced smears on output from Xerox Phaser 5335 Printer?
To resolve equally spaced smears on your Xerox printer's output, try printing a couple of blank sheets to clean the paper path. If that doesn't work, clean the interior of the printer.
How to resolve the lamp is lit on Xerox Phaser 5335?
If the lamp is lit on your Xerox printer, check the control panel for an error message. Follow the instructions provided in the message to clear the error.
Why is the display blank on my Xerox Phaser 5335 Printer?
The blank display on your Xerox printer might be due to the Power Saver mode. Press the button on the control panel to exit this mode. If that doesn't work, check that the power cord is firmly plugged into the power outlet and reboot the printer.
What to do if my Xerox Phaser 5335 Printer requested a print job, but the lamp does not light or blink?
If the lamp on your Xerox printer doesn't light up when you request a print job, first ensure the interface cable is firmly plugged in. If the printer is offline, press the button. If the menu screen is displayed, press the button to exit. Check that the ports to be used are enabled and the protocols are correctly set on CentreWare Internet Services. Finally, verify that the operating environment of your computer, including the print driver, is correctly configured.
How to fix Xerox Phaser 5335 that makes odd noise?
If your Xerox printer is making odd noises, make sure it's installed on a level and sturdy surface. Also, check that the paper trays are pushed in completely. If the noise persists, switch the power off and check for any foreign objects inside the printer and remove them.
How to fix Xerox Printer that does not switch to the Sleep mode?
If your Xerox printer is not switching to Sleep mode, ensure that the sleep mode is enabled. On the control panel, set [Sleep Mode] to [Enable].
To Next Page
General