Phaser® 6180MFP Multifunction Printer
EN - 2
Installing the Windows Printer Driver over Ethernet (Network)
Installing the Windows Printer Driver over
Ethernet (Network)
1. Ensure the printer is turned on and connected to your network.
2. Insert the Software and Documentation CD-ROM into your
computer’s CD-ROM drive. The installer starts automatically.
3. Click the Language button and select your language from the list.
4. Click Install Printer Driver.
5. Select I Agree if you accept the Xerox License Agreement.
6. Select your Phaser 6180MFP Multifunction Printer from the list
of available printers, and then click the Install button.
7. If your printer was not in the list, type the printer’s IP address
directly into the Enter Printer’s IP address field, and then click
the Install button.
8. Print a test page to verify the installation was successful.
Installing PrintingScout Software
1. Click Install Utilities.
2. Click Install PrintingScout, and then click Next.
3. Select your language, and then click Next.
4. When asked to continue, click Next.
5. Select I Accept if you accept the Xerox License Agreement, and
then click Next.
6. Choose the destination folder, and then click Next
7. Verify the folder installation path, and then click Next.
8. When the installer finishes, click Finish.
Continue with the section Setting Up the Printer Features Connecting
over Ethernet (Network) on page 5.
To Next Page
Loading...
Need help?
General
