Xerox PHASER 7500 - Page 6

T
roubleshooting
R
eady To Print
Press ? for help
P
rint Quality Problems
T
roubleshooting
Changing P
aper Type
EN
If y
ou change the type of paper in a tray, you MUST change the paper type on the
control panel to match the paper you just loaded. If you fail to do this, print-quality
problems can occur and the fuser can be damaged.
Use the Up Arrow or Down Arrow buttons to change the paper type, then press OK
to accept the change.
T
ray 2 Paper
Letter LEF (8.5 x 11 in.)
Plain Paper
Use current setup
Change Setup...
Tray 2 Paper
Letter LEF (8.5 x 11 in.)
Plain Paper
Use current setup
Change Setup...
EN
F
or Print-Quality Solutions:
6HHWKH3ULQW4XDOLW\3UREOHPVPHQXDQGSULQWWKH
Troubleshooting Print-Quality page.
6HHWKHTroubleshooting chapter in the User Guide.
For Print-Quality Solutions:
6HHWKH3ULQW4XDOLW\3UREOHPVPHQXDQGSULQWWKH
Troubleshooting Print-Quality page.
6HHWKHTroubleshooting chapter in the User Guide.
P
rint Quality
EN
EN