Xerox Trimmer Module SquareFold User Manual

SquareFold Trimmer User Guide
12
Important!: The top covers cannot be opened during normal
operation or when the machine is idle. The covers can be
opened only
when an indicator is lit (refer to page 4) and a
j
am/fault occurs within the S
q
uareFold Trimmer Module
.
If a jam occurs, the machine stops printing a fault code
appears on the SquareFold Trimmer Module Control Panel,
and a message may
be displayed on the User Interface (UI).
Use the following procedure to clear the jam or fault and
resume printing:
Problem solving
Jam clearance
Clear any paper jams that may occur
along the paper path
2.
The Control Panel on the SquareFold Trimmer Module is
displaying a fault code and/or a fault indicator is lit:
Open the Top Left Cover and the Top Right Cover.
1.
Tip: To determine if the jam/fault is within the finisher or
with the SquareFold Trimmer Module, always begin your
troubleshooting with the SquareFold Trimmer Module.
Note: If a message is displayed on the machine's UI, it will
always indicate a jam/fault within the finisher.
Yes: Continue to the next step of this procedure•
No: Refer to the machine’s UI and clear any possible •
finisher jam/fault.

Xerox Trimmer Module SquareFold Specifications

General

Brand	Xerox
Model	Trimmer Module SquareFold
Category	Printer Accessories
Language	English