Network Scanning Setup (Optional)
Copyright © 2007, Xerox Corporation. All rights reserved.
13
Procedure for Network Scanning
1. At the device select All Services and Network Scanning.
2. Select a template from the list. You can also change any other value from the control
panel without impacting the template configuration; only the current job will be
affected.
3. Load a sample document into the document feeder.
4. Press the green Start button. The job is sent to the server using FTP or SMB protocol
as defined within the template.
5. From a workstation, log on to the FTP or SMB Server. Navigate to the repository
(destination) that was specified earlier. Your scanned document is located in that folder.
If remote authentication has been enabled, a separate login screen appears when
the Network Scanning feature is selected. Documents are not scanned unless the
remote authentication server authenticates user access.
To Next Page
Loading...
