Xerox WorkCentre 7500 Series User Manual

Troubleshooting
224 WorkCentre 7500 Series Multifunction Printer
User Guide
 Loading paper incorrectly.
 Overfilling the tray.
 Adjusting the paper guides improperly.
Most jams can be prevented by following a simple set of rules:
 Use only supported paper. For details, see Supported Paper on page 38.
 Follow proper paper handling and loading techniques.
 Always use clean, undamaged paper.
 Avoid paper that is curled, torn, moist, creased, or folded.
 Fan the paper to separate the sheets before loading it into the tray.
 Remove transparencies from the output tray immediately after printing.
 Observe the paper tray fill line; never overfill the tray.
 Adjust the paper guides in all trays after inserting the media. A guide that is not properly adjusted
can cause poor print quality, misfeeds, skewed prints, and printer damage.
 After loading the trays, select the correct paper type and size on the control panel.
 When printing, select the correct type and size in the print driver.
 Store paper in a dry location.
 Use only Xerox
®
paper and transparencies designed for the printer.
Avoid the following:
 Paper that is specially designed for ink-jet printers with polyester coating.
 Paper that is folded, wrinkled, or excessively curled.
 Fanning transparencies before loading in the tray.
 Loading more than one type, size, or weight of paper in a tray at the same time.
 Loading punched paper or paper with folded corners or staples in the document feeder.
 Overfilling the trays.
 Allowing the output tray to overfill.
 Allowing the output tray to fill with more than a few transparencies.
Refer to the control panel Paper and Media Information Pages for information on supported paper, or go
to www.xerox.com/paper.

Xerox WorkCentre 7500 Series Specifications

General

Brand	Xerox
Model	WorkCentre 7500 Series
Category	All in One Printer
Language	English