5-4
Disassembly and Reassembly
Service Manual
5.4.1 Remove Scanner Ass’y
1. Before you remove the Scanner Ass'y, you should
remove:
-Rear Cover (see page 5-2)
-Side Cover(Left Cover, Right Cover)(see page 5-3)
2. Remove the 2 connectors from the main PBA and
release the ground wire from the Motor Drive Ass’y as
shown below.
3. Carefully lift the Scanner Ass’y from the base taking
care to thread the cables through the frame.
5.4 Scanner Ass’y
< Caution >
1. Before disassembling the Scanner Ass'y first lift
it carefully at the front edge. The support lever
will automatically raise into position.
2. Take care not to trap your fingers or hand in the
mechanism.
To Next Page
Loading...
