5-15
Disassembly and Reassembly
Service Manual
5.15 Feed Roller
1. Before you remove the Feed Roller you should
remove:
- Rear Cover (see page 5-2)
- Side Covers (see page 5-3)
- Scanner Ass’y (see page 5-4)
- Middle Cover (see page 5-6)
- LSU (see page 5-9)
- Drive Ass’y (see page 5-10)
2. Remove 2 screws from the Guide Paper and take it out.
3. Pull up the Feed Idle Bush and Feed Idle Shaft, as
shown below.
4. Remove 3 screws from the Feed Bracket and take it out.
5. Remove the Idle Gear and Feed Gear2.
6. Remove the Feed Gear 1 Ass’y, as shown below.
To Next Page
Loading...
