Installing the 2-in-1 Charging & Storage Mount
1. The 2-in-1 charging & storage mount is an optional accessory,
you can install it based on your requirements.
2. The mount should be installed in a cool, dry place near a power
outlet, out of direct sunlight, and away from moisture-prone areas,
such as a kitchen.
3. Securely install the mount using mounting hardware suitable
for the type of wall selected. Make sure the installation area is
clear of any pipes such as gas or water lines, and air ducts,
electric wires and cables, or drainage lines.
4. It is recommended to hire a professional to install the mount
and to use protective clothing, goggles, and other protective
equipment where necessary.
5. Using an electric drill, mark and drill two 8 mm diameter holes
into the wall where desired to a depth of about 30 mm. Insert the
wall plugs into the holes, position the mount, then fasten it to the
wall with the included screws.
Vacuum and Accessories Installation Diagram
Insert till it clicks into place Insert till it clicks into place
Installation
Recommended Height: 1.06 meters from the ground
Screw Wall Plug
1.06m
5 6
To Next Page
Loading...
Need help?
General
