Cleaning the Cyclone Assembly
1. Rotate the cyclone assembly in the direction illustrated to unlock
it, then remove the cyclone assembly.
3. Once it is dry, reinstall the cyclone assembly.
2. Rinse the cyclone assembly with water until it is clean. To
thoroughly dry the cyclone assembly, keep it in a ventilated or cool
place for at least 24 hours.
Note:
Do not clean the cyclone assembly in a dishwasher or washing machine, and do not attempt
to dry it in a tumble dryer, oven, microwave, or near an open fire.
Tips
Cleaning the Vacuum
Wipe the vacuum with a soft dry cloth.
Always use genuine parts to keep your warranty from being voided.
If the filter or nozzle becomes clogged, the vacuum will stop working
shortly after being turned on. To restore functionality, clean the filter
or nozzle.
If the vacuum will not used for an extended period, fully charge it,
unplug its power adapter, and store it in a cool, low-humidity
environment away from direct sunlight. To avoid over-discharging the
battery, recharge the vacuum at least once every 3 months.
Cleaning the Dust Compartment
Before cleaning the dust compartment, disconnect the adapter and
keep the vacuum's power switch in the off position. The vacuum's
cleaning ability will be reduced if the dust compartment is filled to the
"MAX" mark. To regain performance, empty the compartment.
To empty the dust compartment: Press the release button on the
bottom of the compartment, then empty its contents.
Care & Maintenance
24h
9 10
To Next Page
Loading...
Need help?
General
