What to do if my Xilin Forklifts stacker can not stop during traveling?
If your Xilin Forklifts stacker doesn't stop while moving, immediately cut off the power and replace the contact due to a broken contact preventing reset.
Why my Xilin CDDR15-I stacker can not start (but the contactor works)?
If your Xilin Forklifts stacker won't start, but the contactor is working, it could be due to several reasons: * The side-magnetic brake of the drive wheel does not suck, leaving the stacker braked. In this case you should repair or replace it. * The walking motor carbon brush is worn, or there's bad contact between the steering device and the carbon-brush, so you should repair or replace it. * The magnet-exciting coil of the stepper motor is broken, or there's bad contact at the wire end, so you should repair or replace it. * There is bad contact, so you should repair or replace it. * There is a trouble at the MOSFET tube type circuit board, so you should repair or replace it.
How to troubleshoot brake failure on Xilin CDDR15-I?
If the brake on your Xilin Forklifts isn't working, check these potential causes: * The erection bolt of the fine motion switch is loose or damaged. Adjust or tighten the bolt, or replace the fine motion switch. * The connecting wire of the side-magnet brake is loose or damaged. Tighten the bolt or repair the side-magnet brake. * The braking plates of the side-magnet brake are worn. Replace the braking plates.
Why my Xilin Forklifts stacker won't start and the contactor doesn't work?
If your Xilin Forklifts stacker isn't starting and the contactor isn't working either, it could be due to: * A burnt-out fuse in the control circuit. Replace the fuse. * A power switch with poor connection or damage. Repair or replace the power switch. * A blown fuse in the main circuit. Replace the fuse. * The electric lock switch having a poor connection or being damaged. Repair or replace the switch. * Loose or disconnected storage batteries. Tighten the connections.
What causes a Xilin Forklifts stacker to only move forward or backward?
If your Xilin Forklifts stacker can only move forward or backward, it may be due to: * The contactor is in poor connection or burnt out. In this case you should repair or replace it. * There is malfunction in circuit board, so you should repair or replace it.
Detailed specifications for the CDDR Electric Pallet Stacker models.
Crucial safety regulations and guidelines for operating the electric pallet stacker.
Essential rules for safe operation, load capacity, and handling of goods.
Essential safety warnings and checks to be observed before starting the stacker.
Procedures for dealing with common operational faults and emergencies.
Procedures for the first charge of new batteries, including preparation.
Tips for battery longevity, discharge limits, common charging, and equalizing charge.
Covers battery storage, electrolyte handling, emergency treatment, and charger specifications.
Checklist and content for pre-operation inspection of the electric truck.
Identifies common faults and provides solutions for troubleshooting the electric pallet stacker.
Fundamental rules for drivers, including qualifications, passenger policy, and load carriage.
Maintenance checks for hydraulic systems, batteries, motors, and other components.
To Next Page
General
