In the third menu ,if the parameter has no flashing bit ,it indicates that the function code cannot be
modified . The reasons could be:
1 The function code is an unchangeable parameter , such as actual detection parameter(FV parameter)）
parameter , etc ., running record
2 The function code cannot be modified in running status . It can be modified only after the unit is
stopped .
）
3 Operation panel is on code protection status .）
The inverter can provide 26 kinds status parameter for user . There are two kinds of methods to refer to .
1) When FV status parameter is a group that can only be read , you can use the same way to enter the
three-level menu to viewing the parameter , the detailed operation method shown in 4.2 section . And this
method is convenient to refer to the parameter which doesn’t need to inquire again and again.
2) In stop or running status , the status parameter which needs inquiring again and again is setting by
Our company provide double- range LED operate panel which is optional , the content of under range
is setting F6.05 by correspond to FV parameter number . This way is convenient for client to debug. User
might purchase it selectivity for small power inverters external keyboard because it is common .’
Setup F6.01 to F6.04 properly , display Fv parameter ,which needs to modify on-line ,by pressing shift( )
When one of frequency source selective parameter (F0.03 F0.04) settled to digital setting Up、、DW,
When PID reference source select PID digital reference , after switched display status parameter FV.13、
modify correlative parameter on-line rather than entering three-level menu . Please( )to read FA.11
parameter explanation to know about the operation of exact stop .details
at this time it is switched to display status parameter FV.00 FV.01 FV.03 FV.04 FV.05、、 、、、FV.06 ,
key. Please refer to Group F6 correlative parameter explanation .
running parameter (F6.01 to F6.02) and stop parameter (F6.03 to F6.04) , and to reach to the common
status parameter is by controlling descriptionshift key ( ) to display in turns , the setting methods shown in
of parameter group F6 of function code .
4.3 Method of viewing status parameter
4.4 Digital setting numerical value on-line modification
4.5 Password setting
1 Open-loop running status speed reference on-line modification
2 Close-loop control status PID digital reference on-line modification
3 For correlative parameter of exact stop on-line modification
24
press Increase key /Decrease key to modify F9.02 rather than（）FV.14 , you can on-line entering
three-level menu .
you can modify the set frequency, the set rotate speed and the set line speed through pressingon-line
Increase key/Decrease key ( ).
When it is shifted to display status parameter FV.16 to FV.21 , you can press Increase key / Decrease key
The inverter provides user password protection function . When F6.08 is set to non-zero value , it
To cancel the password protection function , enter with password and set F6.08 to 0 .“”
indicates the user password , and the password protection turns valid after exited the function code editing
status . When pressing FUNC again ,“”0000 will be displayed and indicated user input password , you
is input correctly , or else you can enter functioncan modify parameter normally until user password is
code programme status but all function codes cannot modify .
Chapter 4 Operation and Display
To Next Page
Loading...