Xilinx EH600 A Series User Manual

Group FA
Swing Frequency ,Fixed Length and Count
The swing frequency function is applicable to the textile and
chemical fiber fields and the applications where traversing and
winding functions are required .
The swing frequency function means that the output frequency
of the inverter swings up and down with the setup frequency
(frequency command is selected by F0.07) as the center . The
trace of running frequency at the time axis is shown as the
figure above , in which the swing amplitude is set by FA.01
and FA.02 .
The first part of LED It is used to determine the swing
amplitude benchmark .
：
The second part of LED: Selection of swing
frequency function enabled
whether the
0: Relative to the central frequency , and it is a variable swing
system . The swing amplitude varies with the central
frequency (setup frequency) .
amplitude
1:Relative to the maximum frequency (F0.11) , and it is fixed
swing amplitude system . The swing amplitude is fixed .
Setup range
Setup range
Setup range
Setup range
Setup range
0.0 100.0～％
0.0 50.0～％
If the swing amplitude relative to the central frequency is
selected , the kick frequency is a variable value .
If the swing amplitude relative to the upper limit frequency
is selected , the kick frequency is a fixed value .
0.1 3000.0s～
0.1 100.0%～
Swing frequency : I t refers to the time of a complete cycle of swing
frequency .
FA.04 Time constant of triangular wave boost is relative to
FA.03 swing frequency cycle .
Triangular wave boost time
Triangular wave falling time
＝
＝
FA.03
FA.03
FA.04 unit : s（）
（）1- FA.04)(unit : s
x
x
Kick frequency = swing amplitude AW kick frequency
amplitude FA.02
x
Fig.6-21 Schematic Diagram for Swing Frequency
Running command
Stop command
Time (t)
Frequency cycle FA.03
Setup frequency(Hz)
Frequency upper limit FH
Cetnter frequency Fset
Frequency lower limit FL
Frequency amplitude
Aw=Fset FA.01
Textile kick frequency
=AW FA.02
Accelerate by
acceleration time
Decelerate by
deceleration time
+Aw
-Aw
Triangular wave
=FA.03 FA.04
63
0.0%
0.0%
FA.02
FA.01
00
Factory
default value
Factory
default value
Factory
default value
Factory
default value
Factory
default value
FA.00
FA.03
FA.04
10.0S
50.0%
Chapter 6 Parameter Description
Swing amplitude
setup mode
The first part of LED:swing amplitude
benchmark
0 relative to the central frequency
1 relative to upper limit frequency
：
：
The second part of LED: swing
frequency function enabled
0 disabled：
1 enabled：
Swing frequency
amplitude
Kick frequency
amplitude
Swing frequency cycle
Time constant of
triangular wave boost
The parameter is used to determine the values of swing
amplitude and kick frequency .
Swing amplitude AW (variable swing amplitude) =
frequency source F0.07 swing amplitude FA.01x
Swing amplitude AW (fixed swing amplitude) = upper
frequency F0.11 swing amplitude FA.01x
Prompt the swing frequency is limited by the frequency
upper limit and frequency lower limit .If the setting is
inappropriate , it works abnormally .
：

Xilinx EH600 A Series Specifications

General

Brand	Xilinx
Model	EH600 A Series
Category	Inverter
Language	English