Xilinx EH600 A Series

To Next Page

To Previous Page

within the range of -10 to 50 .℃℃

enough because the inverter will generate lots of heat during running , besides mount the inverter vertically on

the base with screws .

Chapter 3 Mechanical and Electrical Installation

3.1 Mechanical Installation

1、Insatallation Environment

2、Insatallation Location

Insatallation of single inverter Up and down insatallation of inverter

Install an airflow-guidance plate forNote :When the inverter power is notNote :

higher than 22kw ,the A size can be“”

omitted . When the inverter power is

higher than 22kw, the A size should“”

be higher than 50mm .

Fig . 3-1

the up and down installation of inverters .

1) Ambient temperature : ambient temperature influences the life of inverters greatly , so it

should be

2) Mount the inverter in a flame retardant surface and the clearance around the inverter should be

3) Mount in the location where vibration is less than 0.6G;the inverter should be far away from

4) Please do not install the inverter in the place with direct sunlight,high humidity and water .

5) Mount the inverter in the location free of corrosive gas ,explosive gas of combustible gas .

6) Mount the inverter in the location free of oil dirt , dust , and metal powder .

impacting lathe .

≥100mm

EH600

≥100mm