Xinje DP-7022P - Power Terminals; Function; Power Supply Requirements; Wiring

6
Input requirements:
 All the input signals go through the photo-electric isolation please provide at least
8mA control signal to ensure the conduction of built-in high-speed optical
coupler.
 The photo-electric has installed current limiting resistor, all the control signals
connect to +24V.
3-2. Power terminals
3-2-1. Function
Interface
Function
Explanation
U
Motor phase U
Motor phase U input
V
Motor phase V
Motor phase V input
W
Motor phase W
Motor phase W input
PE
Ground
Power supply ground
L、N
Power supply
Power supply input, 200~240VAC
PE
Ground
Power supply ground
P+、PB
Braking resistor
Braking resistor terminal
3-2-2. Power supply requirements
 To keep the normal working of drive, please ensure the power supply in the range
of 200~240VAC.
3-2-3. Wiring
W
PE
L
N
PE
P+
PB
AC200-240
U
V
Notes:
The power supply voltage of driver determines the motor high speed performance (the
larger the voltage, the higher the high-speed torque, can avoid loss of synchronism),
set current determines the motor output torque (the bigger the current, the higher the
output torque).