Xinje ZG3 Series - Page 63

SFD1038
Positive compensation of gear
gap
Negative compensation will also
use this data when gear gap
negative compensation =0
SFD1039
Negative compensation of gear
gap
SFD1040
Low 16 bits of Electrical origin
position
SFD1041
High 16 bits of Electrical origin
position
SFD1042
Mechanical back to origin
parameter setting
Bit0：Switch state setting of near
point, 0 ： Normally ON ；
1Normally OFF
SFD1043
Terminal setting of near point
signal
Bit0~bit7：Assign the number of
terminal X, 0Xff for not terminal
SFD1044
Z phase terminal setting
Bit0~bit7：Assign the number of
terminal X, 0Xff for not terminal
SFD1045
Limit terminal setting
Bit7~bit0：Assign limit 1 number
of terminal X, 0Xff for not
terminal
Bit15~bit8 ： Assign limit 2
number of terminal X, 0Xff for
not terminal
SFD1046
Terminal setting of origin
auxiliary signal
Bit0~bit7：Assign the number of
terminal X, 0Xff for not terminal
SFD1047
Terminal setting of zero clear
CLR signal output terminal
Bit0~bit7：Assign the number of
terminal Y, 0Xff for not terminal
SFD1048
Low 16 bits of return speed VH
SFD1049
High 16 bits of return speed VH
SFD1050
Low 16 bits of return speed VL
SFD1051
High 16 bits of return speed VL
SFD1052
Low 16 bits of crawling speed
SFD1053
High 16 bits of crawling speed
SFD1054
Low 16 bits of mechanical origin
SFD1055
High 16 bits of mechanical
origin
SFD1056
Z phase number
SFD1057
CLR signal delay time
Default 20, unit：ms
SFD936
G instruction parameter group
using choice
Choose the G instruction
parameter group
…
SFD1080
Low 16 bits of pulse default
speed
Only when speed=0, default
speed is used to transmit pulse.
First set of
parameters