Xinje ZG3 Series - Page 80

SFD1691
High 16 bits of Electrical origin
position
SFD1692
Mechanical back to origin
parameter setting
Bit0：Switch state setting of near
point, 0 ： Normally ON ；
1Normally OFF
SFD1693
Terminal setting of near point
signal
Bit0~bit7：Assign the number of
terminal X, 0Xff for not terminal
SFD1694
Z phase terminal setting
Bit0~bit7：Assign the number of
terminal X, 0Xff for not terminal
SFD1695
Limit terminal setting
Bit7~bit0：Assign limit 1 number
of terminal X, 0Xff for not
terminal
Bit15~bit8 ： Assign limit 2
number of terminal X, 0Xff for
not terminal
SFD1696
Terminal setting of origin
auxiliary signal
Bit0~bit7：Assign the number of
terminal X, 0Xff for not terminal
SFD1697
Terminal setting of zero clear
CLR signal output terminal
Bit0~bit7：Assign the number of
terminal Y, 0Xff for not terminal
SFD1698
Low 16 bits of return speed VH
SFD1699
High 16 bits of return speed VH
SFD1700
Low 16 bits of return speed VL
SFD1701
High 16 bits of return speed VL
SFD1702
Low 16 bits of crawling speed
SFD1703
High 16 bits of crawling speed
SFD1704
Low 16 bits of mechanical origin
SFD1705
High 16 bits of mechanical
origin
SFD1706
Z phase number
SFD1707
CLR signal delay time
Default 20, unit：ms
SFD936
G instruction parameter group
using choice
Choose the G instruction
parameter group
…
SFD1730
Low 16 bits of pulse default
speed
Only when speed is 0, default
speed is used to transmit pulse.
First set of
parameters
SFD1731
High 16 bits of pulse default
speed
SFD1732
Accelerating time of pulse
default speed
SFD1733
Decelerating time of pulse
default speed
SFD1734
Acc and Dec time of tween
SFD1735
Reserved