21
901302
SB M3x2.5
305392
P 2x10
305394
P 2x9
902205
SH M2x5
940510
BB 5x10x4
980210
P 2x10
REAR TOE-IN
TRACK-WIDTH
Use Alu 50mm Drive Shafts in rear
OIL
BEARING OIL
(HUDY #106230)
THREAD LOCK
THREAD LOCK
THREAD LOCK
GRAPHITE GREASE
(HUDY #106210)
2x10mm
2x9mm
GRAPHITE GREASE
(HUDY #106210)
GRAPHITE GREASE
(HUDY #106210)
ONLY FOR
REAR
TL
TL
TIP
For easy installation of the #305241
plastic caps, use pliers as shown.
DO NOT OVERTIGHTEN
ECS drive shafts are available in 51mm length in kit, or optional 50mm
& 52mm lengths. The ECS drive shafts were developed to decrease front
wheel vibration when racing with a solid front axle, thus providing a
much smoother and quieter ride and increased steering.
ECS DRIVE SHAFTS
REAR TRANSMISSION
REAR TRANSMISSION
FRONT TRANSMISSION
L=R
TL
INCLUDED
UPRIGHTS
#303351 1° - R MEDIUM (2-HOLE)
#303352 0° - R/L MEDIUM (2-HOLE)
#303353 1° - R HARD (2-HOLE)
#303354 0° - R/L HARD (2-HOLE)
#303360 0° - R/L GRAPHITE (2-HOLE)
#303361 1° - L MEDIUM (2-HOLE)
#303362 0° - R/L MEDIUM (1-HOLE)
#303363 1° - L HARD (2-HOLE)
#303364 0° - R/L HARD (1-HOLE)
#303358 ALU 1° - R/L (4-HOLE)
#303359 ALU 2° - R/L (4-HOLE)
#305242
DRIVE SHAFT REPLACEMENT CAP
3.5MM ORANGE - STRONG (4)
DETAIL STEP
Set-screw against the flat spot.
Set-screw against
the flat spot.
5. FRONT & REAR TRANSMISSION
2x
2x
2x
L=R
0° OUTBOARD TOE-IN UPRIGHTS
Left UPRIGHT = Right UPRIGHT
Longer drive shafts (52mm) make the car easier to drive because they give more traction and better stability, mainly in chicanes.
However, the car will understeer more than with shorter (50mm) shafts which give a lot of steering and make the car more aggressive.
Both left & right shafts should ALWAYS be the same length at one end of the car (front or rear).
52mm shafts are recommended for carpet high-traction tracks.
51mm shafts are recommended for carpet tracks and large asphalt tracks.
50mm shafts are recommended for low-traction or tight asphalt tracks.
The new 51mm drive shafts which are included in the kit are the best compromise between 50 and 52mm lengths.
DRIVE SHAFTS
#305323 50MM - STEEL
#305324 52MM - STEEL
#305326 52MM - ALU
#305332 52MM - ECS
#305333 50MM - ECS
To Next Page
Loading...
