Xray T4 - Page 23

23
901304
SB M3x4
303123-K
SHIM 3x6x2
ROLL-CENTER
ROLL CENTER
CAMBER
901304
SB M3x4
303122-K
SHIM 3x6x1
303127-K
SHIM 3x6x4
The information about the optional Active
rear suspension is at the end of the manual.
1mm
4mm
LEFT UPRIGHT = RIGHT UPRIGHT
L=R
5mm THREAD
8mm THREAD
REAR SUSPENSION
L=R
53.5mm
Install the pivot balls with Professional
Multi Tool (HUDY #183011)
2mm
2mm
5mm THREAD
10mm THREAD
TIGHTEN GENTLY
FRONT SUSPENSION
L=R
2x
55.5mm
Install the pivot balls with Professional
Multi Tool (HUDY #183011)
5. FRONT & REAR TRANSMISSION
TIGHTEN GENTLY
INITIAL SETTING
1:1
25mm
2x
L=R
1-HOLE REAR UPRIGHTS (See page 21)
An optional 1-hole rear upright is available for fine tuning. This optional upright may be
used on high-traction tracks or tracks with long sweepers, since the position of the center
hole will allow faster driving through those corners because of better cornering speed.
#307322 TITANIUM REAR ARM PIVOT PIN (2)
L=R
INITIAL SETTING
2x
1:1
23mm
2x
4L
4R
#307222 TITANIUM FRONT ARM PIVOT PIN (2)
L=R
INITIAL SETTING
2x