23
ROLL CENTER
CAMBER
901304
SB M3x4
303127-K
SHIM 3x6x4
ALU SHIM
3x6x2mm
LEFT UPRIGHT = RIGHT UPRIGHT
L=R
5mm THREAD
8mm THREAD
REAR TRANSMISSION
L=R
53.5mm
Install the pivot balls with Professional
Multi Tool (HUDY #183011)
303123-K
SHIM 3x6x2
5. FRONT & REAR TRANSMISSION
TIGHTEN GENTLY
ALU SHIM 3x6x4mm
INITIAL SETTING
1:1
25mm
2x
L=R
1-HOLE REAR UPRIGHTS (See page 21)
An optional 1-hole rear upright is available for fine tuning. This
optional upright may be used on high-traction tracks or tracks with
long sweepers, since the position of the center hole will allow faster
driving through those corners because of better cornering speed.
#307322 TITANIUM REAR ARM PIVOT PIN (2)
L=R
INITIAL SETTING
2x
To Next Page
Loading...
