Xray X4F'25 - Page 17

17
903306
SFH M3x6
903305
SFH M3x5
303121-K
SHIM 3x6x0.5
901302
SB M3x2.5
901313
SB M3x12
The brace provides chassis flex adjustment possibilities depending on which screws are connected.
CHASSIS FLEX ADJUSTMENT
NOTE ORIENTATION
DETAIL
0.5mm
SHIM
0.5mm
SHIM
CHANNEL
3x5mm
3x5mm
3x6mm
3x6mm
Use only for STIFF setting
0.5mm
0.5mm
Use only for STIFF
setting
3. CENTRAL TRANSMISSION
6mm
2x
3x
2x
2x
2x
2x
The screw presses against the notch.
DO NOT overtighten.
Install the brace using only the 2 forward
bottom centerline screws (as shown). This
gives improved on-power stability but
still offers great off-power steering and
rotation. Recommended for medium-high
traction conditions and for small, technical
tracks with many hairpin corners.
When the brace is NOT installed, the car
will have the most steering and rotation.
However, the car will be more difficult to
drive as it is less stable. Recommended
for medium-high traction conditions and
for small, technical tracks with many
hairpin corners.
Install the brace using all 3 bottom
centerline screws (as shown). This gives
improved on-power stability and traction,
but makes the car push more off-power.
Recommended for low- or high-traction
conditions where stability and traction is
needed.
In addition to installing all 3 bottom
centerline screws, install the 2 side
screws using 0.5mm shims between the
brace and chassis. This setting gives
maximum stability.
SOFT - MEDIUMSOFT - NO BRACE
MEDIUM
STIFF
#303768
ALU CHASSIS T-BRACE - 7075 T6
#303767
BRASS CHASSIS T-BRACE - 8g
ASSEMBLY
VIEW