9
DIFFERENTIAL OIL
Fill differential up to the top of the
diff cross-pins. DO NOT fill the diff
to the top of the housing.
TO ENSURE YOU HAVE THE SAME AMOUNT OF OIL FROM REBUILD TO REBUILD, DO THE FOLLOWING:
➊
Put the diff (without oil) on the scale and
check the weight (approximately 9.80g)
➋
Slowly pour oil into the diff and watch the weight.
LOW TRACTION 50.000cSt (HUDY #106550)
MEDIUM TRACTION 100.000cSt (HUDY #106610)
HIGH TRACTION 500.000cSt (HUDY #106650)
NOTE:
Softer oil increases steering, harder oil increases stability.
FOR CENTER DIFFERENTIAL
#107865
HUDY Ultimate Digital Pocket
Scale 300g±0.01g
g
1 1.00
g
1250
11.00g + 1.50g = 12.50gDiff.
100.000cSt
1. GEAR CENTER DIFFERENTIAL
902306
SH M3x6
903258
SFH M2.5x8
➊
➋
➌
➍
Finish tightening in this order.
Tighten the screws equally but do NOT
tighten them completely.
3x6mm
2.5x8mm
964031
S 3.5x10x0.2
2x
Center diff
Silicone oil 100.000cSt
Fill just above the cross-pins.
OIL
PROPER AMOUNT OF OIL IN THE DIFFS
Use a digital scale to measure the exact amount
of oil in the diff. Remember that during operation
the diff gets hotter and the heat may allow the oil
to expand. If there is too much oil inside it may
interfere with the diff operation and damage the
internal gears.
To Next Page
Loading...
