Xterra TR6.5 - Page 8

TR6.5 Treadmill
7
■ STEP 1
Remove all the parts from the carton and lay the main base frame on a flat level surface.
■ STEP 2
Feed the cable from the base frame (38) through the right side upright tube (5) and slide the tube
into the base frame tube. Be careful not to pinch the wire harness. Install the left upright tube
(4) and just hand tighten for now all eight 5/16” x 1/2“ bolts (94) and the six 5/16” flat washers
(110) for the side bolts and two 5/16” curved washers (95) for the front bolts. Tighten all eight bolts
as tight as possible.
38
5
94
110
95
94
95
94
2
4
5
97
94