When you open the report, located in the header of the table is the workshop information you filled in advance in the system
setup, then the information of the vehicle, as shown below:
Note:
The vehicle information is allowed to edit by clicking the pen icon on the right side of the picture shown above.
You also can click "Print PDF Report" at the bottom right corner to output the pdf report. If you need to close the report tap
on the button “Exit”.
Please follow the below steps to print your report▼
Step 1: Install an APP that can connect to your target printer. Add the printer and input the IP address of the printer in the
APP, or you can contact the XTOOL support team (support1@xtooltech/ support2@xtooltech.com) for help.
The Scantooldoesn’tprovidetheprinterdriversoftware,pleaseinstallathirdpartApponthetabletifyouneedtheprint
your Diagnostic report.
Step 2: On the Android main menu, go to Settings -> Printing-> Turn printer on.
Step 3: Report-> Choose report-> Print PDF Report-> Print
Step 4: Click the top-left corner of the screen and choose the printer previously added. Then click the button on the right to
print.
This function allows you to replay the living data recorded during the Diagnostic process.
To Next Page
Loading...
