Xtool D7S - Page 6

⚫
DB15 to OBD2-16 Main Cable
1.
2.
DB15 Port – connect to tablet
OBD2-16 Male Connector –
connect to vehicle’s OBD port
VEHICLE CONNECTION
The scan tool must be connected to the vehicle’s OBD-II port so that the tablet can establish correct vehicle communication.
Please perform the following steps:
1
2
3
Turn on the tablet
Connect vehicle and tablet via the main test cable
Switch on the ignition and tap on the Diagnostic application to start your diagnosis.
The connection method is shown in the figure below:
1.
2.
3.
Vehicle
DB15 to OBD2-16 Main Cable
Tablet
4