4. Follow the instructions displayed and press OK after completing the instructions shown.
5. Wait until the following instruction is displayed and press OK after completing the instructions shown.
6. Message of ‘Function execution is completed’ displayed when SAS reset function has successfully completed.
THROTTLE
Throttle Position Sensor (TPS) Match, this function enables you to make initial settings to throttle actuators and returns the
“learned” values stored on ECU to the default state. Doing so can accurately control the actions of regulating throttle (or idle
engine) to adjust the amount of air intake.
The operation guidelines of the Throttle function are shown as below:
To Next Page
Loading...
