3.2. Precautions before Use
3.2.1. The vehicle power supply has to meet the normal voltage limits DC 9-15V
3.2.2. Users should check the position of the DLC port and ensure the OBDII 16pin connector and the
DLC port are correctly aligned before attempting to connect.
3.2.3. When taking some special functions tests, users are required to operate the device according to
operating instructions. For vehicle, it has to strictly meet the requirements, for example, the
conditions that some vehicle models need to be reached are as follows: engine temperature
80
℃
/105
℃
, turn off the loads (such as headlights, air-conditioner, etc.), put accelerator pedal in
released position, etc.
3.2.4. If users can not find the tested vehicle model or electronic control system in the X100 PAD2 test
menu, they may need to update the software or consult Xtool technical service department.
3.2.5. Please ensure that only official XTOOL cables and connectors are used to prevent damage to the
unit.
3.2.6. Before powering off the unit, please ensure that you cancel or complete the current task or
function and return to the main interface, then power off.
3.2.7. Do not excessive force to operate the touch screen.
3.2.8. During long period of non-use, please disconnect the power and turn off the X100 PAD2 unit.
To Next Page
Loading...
Need help?
General
