Xtreme Power Conversion 1000VA - Installation and Setup; Installation and Operation Guidelines; Installation Safety Practices

Xtreme Power Conversion Corporaon
T91 User’s Manual
Page 7
Uninterrupble Power Supply
Installaon
• Do not connect appliances or devices which would overload the UPS system (e.g. laser
printers) to the UPS output sockets.
• Place cables in such a way that no one can step on or trip over them.
• Do not connect domesc appliances such as hair dryers to UPS output sockets.
• The UPS can be operated by any individuals with no previous experience.
• Connect the UPS system only to an earthed shockproof outlet which must be easily accessible
and close to the UPS system.
• Please use only VDE-tested, CE-marked (or UL-marked for 100/110/115/120/127 VAC models)
mains cable (e.g. the mains cable of your computer) to connect the UPS system to the building
wiring outlet (shockproof outlet).
• Please use only VDE-tested, CE-marked (or UL-marked for 100/110/115/120/127 VAC
models) power cables to connect the loads to the UPS system.
• When installing the equipment, it should ensure that the sum of the leakage current of the
UPS and the connected devices does not exceed 3.5mA.
•Temperature Rang - Units are considered acceptable for use in a maximum ambient
of 40°C (104°F).
• For Pluggable Equipment - The socket-outlet shall be installed near the equipment and shall
be easily accessible.
Operaon
• Do not disconnect the mains cable on the UPS system or the building wiring outlet
(shockproof socket outlet) during operaons since this would cancel the protecve earthing of
the UPS system and of all connected loads.
• The UPS system features its own, internal current source (baeries). The UPS output sockets
or output terminals block may be electrically live even if the UPS system is not connected to
the building wiring outlet.
• In order to fully disconnect the UPS system, rst press the OFF/Enter buon to disconnect the
mains.
• Prevent no uids or other foreign objects from inside of the UPS system.