Read all safety warnings and instructions. Failure to follow the warnings and instructions may result in injury and/or
property damage. Save all warnings and instructions for future reference. The warning and safety instructions in
this manual are not meant to cover all possible conditions and situations that may occur. Common sense, caution
and care must be exercised when operating or cleaning tools and equipment. Always contact your dealer,
distributor, service agent or manufacturer about problems or conditions you do not understand before operating the
product.
• To reduce to risk of injury, children should be supervised to ensure that they do not play with the appliance.
• To reduce to risk of electric leakage, do not pull the cables when moving the pump.
• Do not use the pump for flammable and/or explosive liquids, such as gasoline, fuel oil, kerosene.
• To reduce the risk of the motor overheating, do not let the water level be lower than the pump itself. Too little
water will not allow the motor to cool down.
• Do not block the pump's pipe or allow an obstruction of the pump. Do not bury the pump in sand or mud.
• Do not allow any wiring, or joints to come in contact with water.
• Never run the pump dry. Doing so will damage the seals, causing leakage. Fill the pump with water before
starting the motor.
• Do not put chemicals directly into the suction inlet of the pump.
• The suction relief valve must be open before the pump can circulate water. Serious injury can result if the relief
valve is not open during operation. Wait 5 minutes before restarting the pump.
• To prevent dangerous or even fatal electric shock, cut off the power supply of the pump before draining.
• If water leakage happens, remove the connector, clean the old raw material belts, and increase one or two laps
of new raw material belts, then reinstall the connector.
• If water leakage happens, remove the connector, clean the old raw material belts, and increase one or two laps
of new raw material belts, then reinstall the connector.
To prevent potential injury and to avoid unnecessary service calls, read
this manual carefully and completely.
The product can be installed only by professionals. Improper installation can endanger
personal safety. The product will not be guaranteed damage caused by improper
installation.
1
To Next Page
Loading...
