9460/9460KP/9462/9462KP System Manual
3-20
Windows may come up with a blank screen when using Windows 3.X with expansion
turned on either through the BIOS setup or the EXP_ON.EXE utility. The two options
(second option being the best) for this situation are listed below:
•
Option 1 – Pressing the
CTRL
-
ALT
-
DEL
keys simultaneously. A blue screen displays,
letting you know that pressing
CTRL
-
ALT
-
DEL
again will reboot the system or press-
ing any key will return you to Windows. At this point, press any key and the normal
Windows screen should appear.
•
Second Option – Turn off the expansion , set the BIOS default in the BIOS setup
menus using the appropriate utility as shown in the
Video Expansion Options
table.
Note
A STN flat-panel display and a CRT cannot be used simultaneously.
Note
For further assistance, call Xycom technical support at 1-800-289-9266.
Touch Screen Drivers
If you have a touch screen factory-installed, you will also receive at no charge: MS-DOS,
Windows 3.x, and Windows 95 touch screen drivers on diskette. Touch screen drivers
for Windows NT (9460-DRVNT) and OS/2 (9460-DRVOS/2) must be purchased sepa-
rately.
The Windows 95 touch screen driver is available in a COM2 and a mouse port version.
Windows NT touch screen driver is
only
available in a version for COM2
Note
If you order Windows NT pre-loaded on a system, the Windows NT
touch screen drivers are provided.
You must install the corresponding touch screen driver software if you change the oper-
ating system. Refer to the touch screen manual for instructions.
Note
If you ordered Windows 95 and a touch screen on your system, the touch
screen driver has been installed. If you ordered Windows NT, the driver
is on a disk and a copy of the driver file is on the hard drive. Windows
NT only supports COM2. Therefore, the touch screen will use the
COM2, so COM2 will not be available for other use.
To Next Page
Loading...