Need help?Do you have a question about the Xylem Flygt 2620.281 and is the answer not in the manual?
General| Brand | Xylem |
|---|---|
| Model | Flygt 2620.281 |
| Category | Water Pump |
| Language | English |
Discusses hazards in temporary installations and biological risks.
Special rules for installations in explosive or flammable atmospheres.
Comprehensive guide to making electrical connections, including precautions.
Essential safety measures before making electrical connections.
Mandatory grounding procedures and safety checks.
Critical safety warnings and requirements before performing maintenance.
Flowchart for diagnosing faults within the pump's drive system.
Procedure for testing stator insulation resistance.
Procedure for removing the mechanical seal and its components.
Steps to pry off and remove the seal housing cover.
Procedure to remove the mechanical seal from the shaft.
Steps to remove the shaft unit from the pump.
Reinstalling seal housing cover screws and removing the shaft unit.
Procedure for removing bearings and retaining rings.
Removing retaining rings and the shaft unit from the intermediate piece.
Procedure for removing the stator from the pump housing.
Steps for installing the stator into the housing using heating.
Procedure for installing bearings and retaining rings.
Steps for installing the shaft unit into the pump.
Procedure for installing the mechanical seal and its components.
Method for checking the seal tightness after installation.
Steps for installing the impeller on drainage versions.
Steps for installing the impeller on sludge versions.
Tasks for overhaul, including bearing and seal replacement.
Safety and best practices for troubleshooting electrical issues.
To Next Page