Electrical Hazard:
1.3 User safety
Introduction
All government regulations, local health and safety directives must be observed.
Prevent danger due to electricity
All danger due to electricity must be avoided. Electrical connections must always be
carried out in compliance with the following:
• The standard connections shown in the product documentation that is delivered
together with the product
• All international, national, state, and local regulations. (For details, consult the
regulations of your local electricity supplier.)
For more information about requirements, see sections dealing specifically with electrical
connections.
1.4 Product warranty
Coverage
Xylem undertakes to remedy faults in products from Xylem under these conditions:
• The fault is due to defects in design, materials, or workmanship.
• The fault is reported to a Xylem representative within the warranty period.
• The product is used only under the conditions described in this manual.
• All service and repair work is done by qualified and authorized personnel. All
modifications must be done by qualified technicians.
• Genuine Xylem parts are used.
Limitations
The warranty does not cover faults caused by these situations:
• Deficient maintenance
• Improper installation
• Modifications or changes to the product and installation made without consulting
Xylem
• Incorrectly executed repair work
• Normal wear and tear
Xylem assumes no liability for these situations:
• Bodily injury
• Material damage
• Economic loss
Warranty claim
Xylem products are high quality products with expected reliable operation and long life.
However, should the need arise for a warranty claim, then contact your Xylem
representative.
Qualification of personnel
WARNING: Electrical Hazard
Risk of electrical shock or burn. A certified electrician must supervise all electrical work.
Comply with all local codes and regulations.
1 Introduction and Safety
MiniCAS II Installation, Operation, and Maintenance Manual 3
To Next Page
Loading...