en – Original instructions
9
2 Transportation and Storage
Packaging inspection
1. Check that quantity, descriptions and product codes match the order.
2. Check the packaging for any damage or missing components.
3. In case of immediately detectable damage or missing parts:
Accept the goods with reserve, indicating any findings on the transport document, or
Reject the goods, indicating the reason on the transport document.
In both cases, promptly contact Xylem or the Authorised Distributor from whom the product was
purchased.
Unpacking and inspection of the product
1. Remove the packaging material from the product.
2. Release the product by removing the screws and/or cutting the straps, if fitted.
CAUTION: Cut and abrasion hazard
Always wear personal protective equipment.
3. Check the product for integrity and to make sure that there are no missing components.
4. In case of damage or missing components, promptly contact Xylem or the Authorised
Distributor.
2.1 Handling the booster set
The booster set must be harnessed and lifted as shown in Figure 1.
WARNING: Crushing hazard (limbs)
The product and its components may be heavy: risk of crushing
Always wear personal protective equipment
Manual handling of the product and its components must be in compliance with the current
regulations on "manual load handling", to avoid unfavourable ergonomic conditions causing
risks of back-spine injury.
Use cranes, ropes, lifting straps, hooks and clasps that comply with current regulations and
that are suitable for the specific use
Make sure that the harnessing does not damage the booster set
During the lifting operations, always avoid sudden movements that could compromise the
stability of the load
During handling, make sure to avoid injury to people and animals, and/or damage to property.
To Next Page
Loading...
General