Xylem Rule 56D - Page 5

DANGER: This product is not intended for damage control or to deal with ooding result-
ing from hull damage. This product is intended to be used in Bilge Pumping Systems for small
craft with a hull length up to 24 meters, as described within the introduction and scope of ISO
15083. Bilge Pumping Systems, as specied in ISO 15083, are limited to normal amounts of
water in an intact boat due to spray, rain, seepage, spillage, and occasional small amounts of
water shipped from boat movements in heavy weather. Use of product in any other way could
result in ooding, catastrophic damage to craft, serious personal injury, or death.
WARNING: This pump is designed for use with fresh water and salt water ONLY. Use with
any other hazardous, caustic, or corrosive material could result in damage to the pump and
the surrounding environment, possible exposure to hazardous substances and injury.
WARNING: Check the function of all bilge pumps at regular intervals. Clear pump
inlets from debris. If seacocks are tted in the fore and aft peak bulkheads, they shall be
kept closed and shall only be opened to let water drain into the main bilges.
STOP
C
STOP
ARRÊT
STOPP
ALTO
5