ā UTILITIES > CLEAN NOZZLE
Printer Maintenance
UTILITIES
BUILD SAMPLE
CHANGE NOZZLE
CLEAN NOZZLE
Regular cleaning of the print nozzle facilitates to not only extending service life of the printer, but also improves print
quality.
Enable "CLEAN NOZZLE" (nozzle cleaning) function. Clean the nozzle after the nozzle is heated up, the bed has
been lowered and the extruder has been moved to the front end, and "READY FOR CLEAN" is displayed on screen.
Clean the detecting pin with Copper Brush
Filament residues produced during printing may become
attached to the nozzle and gear of print module to
influence print quality, operation of the printer, and
measurement result of the bed. If such a situation is
encountered, please use a copper brush to clean the print
module by brushing off residue and dirt on the detecting
pin .
Clean Nozzle with Nozzle Cleaning Wire
With increased print frequency, the carbon accumulation
and dirt in the nozzle might affect print quality.
Thus, we recommend you to clean nozzle for every 25
hours of print. Please clamp the nozzle cleaning wire
with needle-nosed pliers to insert it into the opening of
the nozzle carefully for cleaning.
Wipe Measurement Points
After the bed is lowered, please switch off power to
cool the bed, followed by wiping 3 measurement
points with damp cloth
1
2
3
Printer screen menu, functions and messages
To Next Page
Loading...
Need help?
General
