26 // YAASA ADJUSTABLE BED OWNER‘S MANUAL 27YAASA ADJUSTABLE BED OWNER‘S MANUAL //
DISASSEMBLY
To disassemble Yaasa Adjustable Bed follow the actions of the assembly instructions in reverse
order.
NOTICE
After the side to side cable gets unplugged and reconnected a drive reset must be performed.
Perform a drive reset by pressing the Flat Position button for at least 15 seconds. The remote
control displays “F” to confirm the input. Then the bed will move into the flat position and resets
the drive position.
05
To minimize the risk of pinch-
ing when transporting the side
rails, secure all moving parts
with packaging tape by wrap-
ping it all around the shown ar-
eas.
CAUTION
Do not grab the side rails by moving parts. Always grab them by the rigid frame.
TRANSPORTATION
The fully assembled bed may only be moved a moderate distance to adjust the position in a room.
To move the bed one person must lift the bed on each of the side rails.
CAUTION
Do not grab the side rails by moving parts. Always grab them by the rigid frame.
CAUTION
Do not tilt the assembled bed upright to move it.
NOTICE
Do not tilt the bed to move it. Do only move in horizontal position.
When moving to a different location, the bed must be disassembled.
Disassembly &
Transportation
To Next Page
Loading...