Yadea C1S - Security and Control Systems; Anti-Theft Remote Control Operation; Left Handlebar Controls

ATTENTION
●Turn on the turning light before turning and turn off the
turning light in time after turning.
Single mileage clear
High beam/Low beam
Turning light
Horn
Lock
Lock/Unlock
Mechanical key
In unlock state, short press lock/unlock button,
the alarm enters anti-theft state.
Short press: time≤1.5S, Long press: time≥1.5S.
In lock state, long press lock/unlock button,
the alarm will play seek sound and light effect.
In unlock state, long press lock/unlock button,
the alarm system enters seat electric lock to
unlock seat cushion(if applicable).
In lock state, short press lock/unlock button,
the alarm enters unlock state.
Unlock
Seek
Seat
cushion lock
17 18
Left switch groupAnti-theft alarm(If applicable)
1.Single mileage clear: Long press “SET” button over 5S.
2.High beam and low beam switch: When the headlight
switch is turned on, short press the button to change
high beam and low beam.
3.Turning light switch: Push the switch button to the left
or right to turn on the turning light at the corresponding
position and send out a continuous flashing orange light
signal. At the same time, the speedometer sends out a
green turn indicator signal. After the switch is reset to
the middle position, press the switch to turn off the
turning light.
4.Horn button: Press the horn button to start the horn.
The key operation of the above remote control requires
the remote control to be within 30 meters of the scooter.