Yadea E8S - Anti-Theft Alarm System Functions; Battery Management; Battery Charging Procedure

17 18
6. Battery Charging
The charging hole
1. Insert the charger into the charging hole first, and then add
the mains power;
2. When sufficient, cut off the electricity first, and then pull out
the battery plug.
Tip: The charger grid flickers to indicate that it is
charging.When charging is completed, all grids are
always on. Pleasepower off when the battery is
full.
ATTENTION：
Note: The above remote control button operation shall be
within 30 meters of the scooter.
Unlock
Lock
Quick start
Seek scooter
Set up defenses:
Tap or remote control away from the scooter 3 meters
away, burglar alarm into the anti-theft state!
Unprecation:
Lightly press or the remote control is close to the scooter
within 2 meters, the alarm will enter the state of disarming.
Quick start:Press twice in a row, and the scooter will be turned
on, and the meter will light up.
Seek scooter:Press lightly within 30m of the scooter, and the
scooter will sound a prompt.
Anti-theft alarm (if applicable)