EasyManua.ls Logo

Yadea PREMIUM E-MOBILITY - Battery&Charger Use and Maintenance

Yadea PREMIUM E-MOBILITY
20 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Operation Guide Battery&Charger Use and Maintenance
1. When the scooter is completely stopped, the turning light switch turns off and the key is turned to the OFF position.
2. When parking, people stand on the left side and flat ground to step on the pedal lever of the main support,
step down with force and lift up with right hand. When you leave the scooter, in order to prevent the scooter be stolen,
please be sure to lock the anti-theft lock and take away the key.
General use instructions and warnings
1.Never short circuit the discharge or charge terminals of the battery.
2.Never charge the battery by discharge terminals or discharge the battery by charge terminals.
3.Keep off the battery from fire and excessive heat. Never put the battery into fire.
4.To avoid damage to the battery, never subject it to intense physical shock or severe vibration or impact .
5.Protect the battery from water or other moisture. Protect the discharge and charge terminals of the battery from rain
or water logging.
6.Operating temperature range when charge: 0~45
7.Operating temperature range when discharge-2045
8.Humidity while battery in working state≤80% RH
9.Keep the battery away from children.
10.When the battery is not in use for an extended period of time, remove the battery from the load for storage.
11.If you have any questions about this battery or its usage,please do not hesitate to contact the customer service department.
12.Never disassemble the battery without permission If you failed to comply with the instructions and warnings described
above, you would be responsible for the deed.
1. Turn the power switch to the ON position, whether all kinds of lights are on, whether all switches are working,
whether the horn is ringing, and whether the gate switch is normal.
2. If there is no difference, lay down the main bracket to make the rear wheel touches the ground.
3. After seated correctly, turn on the power lock and press the p switch. when the display interface of the
instrument jumps from the " p" screen to the " GO" screen, the p is unlocked and the whole vehicle can ride at this time.
1. When braking, It is recommended to brake the rear wheel before the front wheel, The effect is the best.
2. After returning the throttle quickly, hold the brake handle tightly.
3. The best way is to brake slowly and then tighten it.
4. Do not brake sharply or turn sharply. Emergency braking and sharp steering are the main factors causing sideslip
or rollover, which are extremely dangerous.
Locating
Start the scooter
Use of brake
18 19

Related product manuals